Protective oil-glaze Effect

Advantages

• Based on natural oils, for all types of wood;
• Allows wood to breathe freely;
• Reduces wood deformation and cracking;
• Repel water;
• Resistant to weather conditions and UV rays;
• The surface does not crack, split or peel;
• No sanding is required during the upgrade;
• Simple and even coverage;
• Protects wood from mold, rot, lichens and insects.

Surface preparation

1. Mix very well with a spatula before use;
2. The surface must be clean, dry and not too cold (no wetter than 20%);
3. Osmo Protective Oil-Glaze is a ready-to-use product, do not tint;
4. Clean old coatings. Old paints and varnishes must be completely removed;
5. It is always recommended to do tests and make sure that the result obtained meets expectations;
6. If possible, apply the first coat thinly on all sides before installing the wood;
7. For additional protection against blue stain, rot or insects, use Osmo Impregnating Agent WR*. Apply one coat to the wood before oiling.

Instructions for use

1. Mix very well with a spatula before use;
2. Clean old coatings. Old paints and varnishes must be completely removed;
3. Apply thinly and evenly to a clean and dry surface along the wood grain with an Osmo natural bristle brush or Osmo microfiber roller;
4. Allow to dry for approximately 4-6 hours, ensuring good ventilation;
5. Once dry, apply a second layer in the same thin layer;
6. For additional protection against blue stain, rot or insects, use Osmo Impregnating Agent WR*.
7. When renovating, one coat on a dry and clean surface is sufficient.
8. After all work is completed, it is advisable to clean the tools with Osmo thinner, brush cleaner (without aromatic compounds) or white spirit.

Note: The final shade may vary from the one shown, as it is influenced by the different characteristics of the wood. It is recommended to use a dust mask during sanding.

Drying time

Dries in approximately 4-6 hours (under normal conditions: 23 C and 50% relative humidity). Lower temperatures and/or higher humidity may significantly extend drying time. Ensure good ventilation throughout the drying period.

Coverage

1 litre covers approximately 26 m2 of planed wood in one coat. The product yield depends greatly on the characteristics of the wood. All information is given for a smooth and planed/sanded surface. Other surface configurations may reduce the coverage.